Knitting An Egg With Little Wool



I found detailed instructions on the internet and I liked. It's easy to knit
This pattern uses oddments of  4 ply yarn. My tension works out to 8 stitches and 10 rows per inch.

The egg is knitted flat and then seamed using mattress stitch. You can stuff the finished egg with polyfil / wool / cotton wadding or it will fit around a polystyrene egg


Row 1: Cast on  11 stitches (leaving a length of yarn about 6 inches for sewing up later)
Row 2: Purl
Row 3: K2, (*M1, K1) 8 times, K1 (19 stitches) *M1=make one,
Row 4: Purl
Row 5: K2, (M1, K1) 16 times, K1 (35 stitches)
Row 6: Purl
Row 7: Knit
Row 8: Purl
Row 9: K3, M1, (K2, M1) 6 times, K3, M1 (K2, M1) 7 times, K3 (50 stitches)
Row 10: Purl

Row 11: Change to yarn colour for pattern band - work chosen pattern band over the next 12 rows (see charts below for pattern suggestions) or simply use a contrasting colour for middle 12 rows.

Zig zag pattern using 3 colours:
  Polka dot pattern using 2 colours:

Stripe pattern using 2 or more colours:
Or why not design your own band (50 stitches x 12 rows):
Row 23: change yarn colour and work 2 rows without shaping
Row 25: K3, K2 tog, (K2, K2tog) 11 times, K1 (38 stitches)
Row 26: purl
Row 27: K2, K2 tog, (K1, K2tog) 11 times, K1 (26 stitches)
Row 28: purl
Row 29: knit
Row 30: purl
Row 31: K1, (K2 tog) 12 times, K1 (14 stitches)
Row 32: purl
Cut the work from the yarn leaving an end around 6 inches long, thread end through stitches on needle and pull up tight. Use this end to begin sewing up the seam. Sew around 1 inch of seam and then begin seaming at other end of egg.

If you want to hang the egg as a decoration then cut a length of ribbon and tie the ends together. Thread the loop through the gathered stitches at the pointed end of the egg leaving the knotted part inside.

At the other end of the egg thread the length of yarn left by the cast on and use to catch up the 11 stitch loops and up pull tight. Continue in mattress stitch to close the seam - leaving around 2 inches of unclosed seam to stuff the egg (if using polyfil or similar). If you are fitting it around a polystyrene egg just sew around half an inch of seam at either end and close the rest of the seam with the polystyrene egg in place.

When the seams meet tie off ends and thread inside trimming off any excess ends.